Muscular electrostimulator is light and portable, easy to use and transport.
4 electrodes, 2 cables and 2 batteries AAA included.
16 automatic programs for rehabilitation, slimming and tonification.

CAUTION: This device has a power saving mode whereby if the electrodes are in contact with the skin on power, it enters power saving mode after a few seconds and turns off.

The use of the equipment is very simple:
Electrodes are applied in the area that corresponds to a bit of gel on them to maintain a moist layer of rubber between the electrode and skin, and held with rubber bands.
Electrodes are plugged into the computer.
The pulse width knob is set to the minimum, and the frequency (pulses per second) as indicated in each case.
The pulse widths are recommended only when there is low sensitivity nerve or muscle.
Is turned on and slowly increase the amplitude until you feel a tingling, pricking, local numbness or heat, it must be no cause burning or pain.
 
TREATMENT OF PAIN
 
In the case of pain management should be held for one or two minutes, time which should reduce the tingling, etc.
This increases the amplitude until it again tingling, etc.
The times for relief may be 5 to 15 minutes, sometimes less.
Treatments should not be less than an hour and can be up to four hours.
After implementation, the pain relief may take several hours.
There are cases where stimulation should be permanent.
There are other cases that after using 2 or 3 times daily 2 hours, several days after 30 minutes a day is enough.
 
THE STIMULATOR TENS transcutaneous nerve is called by its acronym in English, ELECTRICAL TRANSCUTANEAL Nerve Stimulation.
 
According to bibliographic compilations, the frequency of about 100 Hz (pulses per second) excite the afferent nerve pathways to block pain transmission (Control Gate Mechanismus).
The frequencies of 2-10 Hz (pulses per second) are best placed to release endorphins and relieve pain through these substances.
The frequency of 100 Hz produce a tingling sensation and is more bearable than the low frequencies.
The frequencies of 10 Hz or less, produce an unpleasant sensation for some patients, these impulses cause muscle contraction that is exactly what caused indirectly by the anti-pain.
A compromise is to use as infrequently as possible to produce a sense of continuity. This frequency range around 30 Hz (pulses per second).
 
Observe the light and low-frequency basis, to increase this to the point where the light just seems to continue.
In the case of high frequency lock, this is exciting on one or more sensory dermatomes.
In the case of low-frequency lock, the idea is to excite dermatomes engines.
 
ELECTRO-MUSCLE STIMULATION
 
Applications are made at frequencies of 6-500 PPM (6-500 beats per minute).
It is indicated for:
Lost muscle tone after a prolonged plaster or similar situation.
Tighten flabby body parts for cosmetic reasons.
Reviving the bloodstream through muscular movement forced by the TENS
Electric massage.